熱門關鍵詞: 液壓升降平臺 導軌式升降機 移動式升降平臺 固定式升降機 鋁合金升降平臺
重慶升降機鏈條可以根據貨物的提升高度不同調節鏈條的長度,是升降貨梯必不可少的,、重要的傳動裝置,,對提高升降機的作業效率,擴大升降貨梯的作業范圍起著重要作用,。那么貨梯鏈條到底要如何進行保養呢,?
1、貨梯鏈條的松緊度應適宜,,太緊增加功率消耗,,軸承易磨損太松鏈條易跳動和脫鏈。鏈條的松緊程度為:從鏈條的中部提起或壓下,,兩鏈輪中心距約為2%-3%。新的升降貨梯鏈條過長或經使用后伸長,,難以調整,,可看情況拆去鏈節,但必須為偶數,。
Cargo lifter chain tightness should fit, tight increase in power consumption, bearing wear chain is too loose and easy to beat off the chain. Tightness of the chain as follows: Lift or pressure from the middle of the chain, the two sprocket center distance of about 2% -3%. The new cargo lifter or after the use of long chain elongation, it is difficult to adjust, you can remove the link to see the situation, but it must be even.
2,、舊的貨梯鏈條上不能與部分新鏈條混合使用,鏈輪磨損嚴重后,,應同時更換新鏈輪和新鏈條,,以保證良好的嚙合,不能只單獨更換新鏈條或新鏈輪,,否則會造成嚙合不好加速新鏈條或新鏈輪的磨損,,鏈輪齒面磨損到一定程度后應及時翻面使用,從而延長使用時間。
Zhejiang old freight elevator chain should not be mixed with some new chain, sprockets badly worn, it should also replace the new sprocket and new chain, to ensure good engagement, not just a single replacement or new sprocket chain,otherwise it will cause meshing well accelerate new chain or sprocket wear new sprocket tooth wear to a certain extent, upside should be used to extend the use of time.
3,、貨梯鏈條在工作中要記得及時加注潤滑油,,鏈輪裝在軸上應沒有歪斜和擺動。
Zhejiang Huoti chain at work in time to remember filling oil, sprocket mounted on the shaft should not skewed and swing.
4,、貨梯鏈條應做好日常清理工作,,更換時型號應保持一致,不同的型號在更換后會導致貨梯的壽命縮短,。
Zhejiang freight elevator chain should do routine clean-up work, the model should be consistent when changing, different models will lead to the freight elevator after replacing a shortened life expectancy.
咨詢熱線
189-0831-8192